Documentation/Getting started/Install and update

Installation, first launch and updates

One installer for your system, no sign-up. Below — which file to take, what the app asks on first launch and how it updates.

Which file to take

Windows 10 and 11 on an x64 processor. An ordinary installer: download it, run it — done.

First launch

The setup wizard takes you through five steps. Any step can be skipped — you can come back to it in the settings.

  1. 01

    Country

    The app guesses it from the system — correct it if it is wrong. Ready-made site sets for the rules are picked for the country.

  2. 02

    Rights

    On Windows the app needs administrator rights: without them it cannot bring the tunnel up or turn on the kill switch. On macOS and Linux a system component is installed once — the system will ask for a password.

  3. 03

    VPN clients

    Nearly everything is already inside the app. A separate module is only needed if you have a configuration that requires one: the app shows which module and installs it by itself.

  4. 04

    Your first profile

    Paste a link or a subscription from the clipboard, open a file, or drag it into the window. You can skip this and add one later.

  5. 05

    Protection

    The kill switch, reconnecting after a drop, the “is traffic flowing” check, autostart and “Connect at startup”. The recommended options are already ticked; everything can be changed later in Settings.

Updates

The app updates itself: a notice at the top of the window tells you about a new version.

The notice about a new version: “What's new” and “Update”
  • The notice about a new version — “What's new” shows what has changed; “Update” installs the version and restarts the app. You can close the notice and update later from Settings → About.
  • Automatic check — Every few hours. It can be turned off in “About”; the “Check for updates” button and the version history are there too.
  • Install without asking — The app installs a new version by itself — but only while the VPN is off: an update will not interrupt a connection.
  • Installer signature — The update is signed with our key. The app will not install a file that we did not release.
“About”: the version, updates and the data folder

If something is wrong

Windows asks for permission at every launch

Then “Start with Windows” is off — turn it on in Settings → System: the app will start with the rights already in place, without a prompt. It is on from the install.

On a Mac or Linux it says “The system component is not installed”

The tunnel cannot come up without it. Click the button in the notice at the top of the window and enter the system password — the component is installed once.

How do I make sure the installer is genuine?

Compare the SHA-256 checksum: it is shown on the Download page next to the file, along with the command to check it.